HOME   |    PDF   |   


Title

Flexural strength comparison of conventional and CAD/CAM additive provisional restorative materials: An in vitro study

 

Authors

Mitumani Baishya1, Jitendra Khetan1,*, Namrta Mahajan1, Akanksha Anand1, Shiv Kumar1, S.K. Afreen1, Jainey Patel1, Toral Ahir1 & Mansi Tanwar2

 

Affiliation

1Department of Prosthodontics, Nims Dental College and Hospital, Nims University, Jaipur, Rajasthan, India; 2Department of Conservative Dentistry and Endodontics, Nims Dental College and Hospital, Nims University, Jaipur, Rajasthan, India; *Corresponding author

 

Email

Mitumani Baishya - E-mail: mitumanibaishya123@gmail.com
Jitendra Khetan - E-mail: khetan2jit@gmail.com; jitendra.khetan@nimsuniversity.org
Namrta Mahajan - E-mail: namarta.mahajan000@gmail.com
Akanksha Anand - E-mail: akankshaanand29@yahoo.in
Shiv Kumar - E-mail: kumars06929@gmail.com
S.K. Afreen - E-mail: sheenax6018@gmail.com
Jainey Patel - Email: jaineypatel30@gmail.com
Toral Ahir - E-mail: toralahir23@gmail.com
Mansi Tanwar - E-mail: mansitanwar1226@gmail.com

 

Article Type

Research Article

 

Date

Received October 1, 2026; Revised October 31, 2026; Accepted October 31, 2026, Published October 31, 2026

 

Abstract

Provisional restorations require adequate flexural strength to withstand functional forces during clinical service. Therefore, it is of interest to compare the flexural strength of CAD/CAM additive-manufactured and conventionally fabricated provisional restorative materials using 52 standardized specimens. The additive-manufactured specimens showed significantly higher flexural strength than the conventionally fabricated specimens. Thus, data shows the potential of additive manufacturing as a mechanically advantageous approach for provisional restorations, although further clinical investigations are required to establish its long-term effectiveness.

 

Keywords

Computer-Aided Design (CAD)/ Computer-Aided Manufacturing (CAM), additive manufacturing, 3d printing, flexural strength, provisional restoration, digital dentistry, fixed prosthodontics

 

Citation

Baishya et al. Bioinformation 22(10): 6936-6940 (2026)

 

Edited by

P Kangueane

 

ISSN

0973-2063

 

Publisher

Biomedical Informatics

 

License

This is an Open Access article which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly credited. This is distributed under the terms of the Creative Commons Attribution License.