HOME   |    PDF   |   


Title

3D-printed bioactive scaffold for alveolar bone regeneration: An in vitro study

 

Authors

Sadef Naqvi 1, Charu Sharma 2, Nikil Kumar Jain 3, Karthikeyan Vasudevan 4, Manish Suresh Agrawal 5,*, & Aalhad Vivek Chati 5

 

Affiliation

1Department of Pediatric and Preventive Dentistry, NIMS Dental College, Jaipur, India; 2Trusmile Dental Clinic, Chandkheda, Ahmedabad, India; 3Department of Oral and Maxillofacial Surgery, Kalinga Institute of Dental Sciences, Bhubaneswar, Odisha, India; 4Department of Prosthodontics, SRM Dental College, Ramapuram, Chennai, Tamil Nadu, India; 5Department of Orthodontics and Dentofacial Orthopaedics, Bharati Vidyapeeth (Deemed to be) University Dental College and Hospital, Sangli, Maharashtra, India; *Corresponding author

 

Email

Sadef Naqvi - E-mail: sadefnaqvi00@gmail.com
Charu Sharma - E-mail: charusharmasls@gmail.com
Nikil Kumar Jain - E-mail: nikiljainomfs@gmail.com
Karthikeyan Vasudevan - E-mail: drkarthikvasudev@gmail.com
Manish Suresh Agrawal - E-mail: drmanishortho2011@gmail.com
Aalhad Vivek Chati - E-mail: aalhadchati29623@gmail.com
 

Article Type

Research Article

 

Date

Received October 1, 2026; Revised October 31, 2026; Accepted October 31, 2026, Published October 31, 2026

 

Abstract

Three-dimensional printing permits porous scaffolds with controlled geometry, but bioactive reinforcement must enhance osteogenesis without compromising print fidelity or mechanical performance. Therefore, it is of interest to compare the 3D-printed polycaprolactone (PCL), PCL/20% β-tricalcium phosphate (β-TCP) and PCL/20% β-TCP/10% 58S bioactive-glass scaffolds. Dimensional accuracy, porosity, compressive strength, degradation, apatite formation, stromal-cell viability, alkaline phosphatase activity and mineralization were evaluated. The bioactive-glass group maintained approximately 70% porosity, showed the greatest simulated-body-fluid apatite coverage and produced significantly higher ALP activity and mineralization than both controls (p < 0.001), while compressive strength remained within a cancellous-bone range. Thus, bioactive-glass reinforcement improved the in vitro osteogenic performance of the printable scaffold without an unacceptable loss of geometry or strength.

 

Keywords

3D printing, bioactive glass, alveolar bone, scaffold, polycaprolactone, osteogenesis

 

Citation

Naqvi et al. Bioinformation 22(10): 7503-7507 (2026)

 

Edited by

Ashwini Dhopte

 

ISSN

0973-2063

 

Publisher

Biomedical Informatics

 

License

This is an Open Access article which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly credited. This is distributed under the terms of the Creative Commons Attribution License.